Webnotes:  Download

Strand7 Webnotes - Request Page


Preparing Webnote ST7-1.50.10.1 for download...


1.1 MB
ST7-1.50.10.1 Surface Automeshing Geometry and Hex Extrusion
It is often optimal to use a combination of automeshing and manual meshing. This Webnote covers an example of a reinforced end detail of a steel pile, which is first automeshed then extruded into a solid hexahedral mesh.  The given geometry consists of 6 faces. These faces partially overlap, which will have to be corrected before automeshing can be successful. The 3D mesh to be built is shown below. Open ST7-1.50.10.1 Cruciform.st7. Use Tools/Geometry Tools/Graft Edges to Faces. ...
     About Us  |   Contact Us  |   Sitemap  |   中文(简体)网站
     Demo Software  |   Newsletter  |   Copyright  |   Disclaimer