Webnotes:  Download

Strand7 Webnotes - Request Page


Preparing Webnote ST7-1.50.20.2 for download...


0.6 MB
ST7-1.50.20.2 Meshing a Plate with a Hole
This document steps through the procedure required to create the mesh for a plate with a hole in it. One method for refining the mesh around the hole will be discussed. The example will build a plate 600 mm long by 400 mm wide. A hole 100mm in diameter is located directly at the centre. Due to the symmetry of the plate, only one quarter of the full model needs to be created. The full mesh can be created later by mirroring the quarter model.  Select File/New from the main menu and set the...
     About Us  |   Contact Us  |   Sitemap  |   中文(简体)网站
     Demo Software  |   Newsletter  |   Copyright  |   Disclaimer